|
Twaron hull, a carbon aramid fiber with alternating FRP glass lay up, hand laid with no core and using vinylester resins and Isophthalic gel coat.
Two epoxy barrier coats below the waterline for optimal protection
Two coats of Micron CSC Bottom Paint. Third coat around waterline to a depth of four feet
Anchor and sail lockers as watertight collision bulkhead forward of forward cabin with independent overboard drainage. Secondary drainage installed with shutoff to main bilge
Watertight stern sections across aft port and starboard lazarettes and stern locker (garage)
Divided anchor locker. Anchor locker drains directly overboard. Access available from sail locker to forward anchor locker
Large aft stern lazarettes, port and starboard with dual Bailey latches for watertight seal
Dedicated Rule 2200 Auto bilge pump with manual override in cockpit for stern garage section
Very large step down sail locker forward with separate stainless access hatch. Sail locker is also a watertight bulkhead.
Solid lead keel with solid 35mm stainless steel keel bolts with transverse mounted 8mm backing plates. Option for centerboard design with 7'8" draft with board up and 12' draft with board down
Rudder is 60% skegged allowing for optimal performance under power while offering strength and protection for rudder post and bearings
Bottom of rudder plane in each model above the keel plane for grounding safety
Solid Twaron/FRP deck without coring in all areas of deck for deck fittings and stress area
Molded contrasting non skid available in two colors: linen beige or whisper gray
Solid stainless stem head fitting with split bow roller with stowage for 90lb CQR and 90lb Bruce. Owner has a choice of which primary and secondary anchors are to be installed
Solid stainless striker plates for bow protection
Salt-water washdown pump for anchor washdown
Six pair of 12" stainless deck cleats. Two pair at the bow, two pair midship cleats and two pair of 12" stern cleats
32" high stanchions 1 ¼" in diameter with double lifelines
Mainship 316 flush mounted stainless overhead hatches and ports throughout including:
Mainship Low profile S/S LDH 10" x 10" - HATCH FOR FWD HEAD
Mainship Low Profile S/S LDH 19-1/2" X 19-1/2" - HATCH FOR THIRD & AFT CABIN
Mainship Low Profile S/S LDH 24" X 24" - HATCH FOR FWD CABIN & SALOON
Mainship Low Profile S/S LDH 24" X 24" - HATCH W/ LOCK FOR SAIL LOCKER
Mainship Low Profile S/S 5" X 12" X 1-5/8" - Opening Port lights above galley. Three total
Mainship Low Profile S/S 7" X 14" X 1-3/4" - Opening Port light for each cabin
Winch Inventory:
Primary Winches: 2- Antal CHST 80.3's Hydraulic (mounted side-cockpit fwd)
Secondary Winches:2-Antal CST 66's. Manual Winches. Hydraulic Optional
Mainsheet Winch: 1-Antal CHST 66 Hydraulic (mounted aft cockpit c/line)
Cockpit Winch: 1- Antal CHST 66 Hydraulic (mounted coach roof-stbd)
Halyard Winches: 2- Antal CHST 52's Manual ( mounted on mast)
Traveler winches: Antal 40's CHST Manual
Own has choice of Hydraulic push button controls at winch location or helmsman position
Teak handrails on foredeck coach roof and aft coachroof. All handrails to be either teak or stainless included as standard
Stainless steel companionway handrails
Stainless coachroof handrails
Whitlock "Regal" Model Pedestal. Several different options for binnacles offered for electronics mounting. Dual walkthrough design has molded pedestals
Whitlock Mamba Mechanical Steering System
Lewmar 135 Compass
Aqualoy 22 Shaft WBM 2"X115"
Stern boarding ladder-Fold down stainless and teak . Ladder reaches a five foot (5') depth
Side boarding ladder-Fold down stainless and teak. Ladder can be mounted on either port or starboard side
Marinco 50A/220V and 50A 220/125V shore power connections
3" Copper Grounding Strap both Port and Starboard
Lewmar Ocean Series V4 Chrome plated Bronze Hydraulic Windlass
Primary anchor and tackle: 300' system 40 triple B 1/2" galvanized chain with primary anchor
Secondary anchor and tackle: 100' system 40 triple B 1/2" chain and 300' of 3/4" anchor rode with 2ndary anchor
Six dock lines. 4@ 50' x 3/4" and 2@75' x 3/4 Premium Braid New England
Three 10 X 26" Taylor fenders
Owners choice for one of the two following rig options:
LeisureFurl Hydraulic In Boom Furling with dedicated hydraulic halyard and boom controls or
Selden Hydraulic In Mast Furling system with hydraulic outhaul controls.
Furlex Hydraulic 500 Series Forestay with cockpit controls
Furlex 400 Series Inner Forestay with clutch aft at 2ndary winches
Forespar Mast
Navtec System 50 Hydraulic Backstay
Navtec System 50 Hydraulic Vang
All standing rigging is Navtec Rod Rigging. All rod will be measured and cold headed during commissioning
Doyle Sails including full battened mainsail and 135% Genoa with Sunbrella cover.
Primary and secondary main SPECTRA Halyards
Primary and secondary genoa SPECTRA Halyards
Halyard bales on forward dorades
PBO Single Line Running Backstay system
Main Traveler track, car and winches to be added, for main sheet system with main sheet stand-up block similar to Hy54's design
Yanmar Model 4LH-STP 240hp diesel engine with cockpit controls and complete alarm system
Fisher Panda PMS 12KW E 240/120 V AC 60 HTZ GENERATOR
Lewmar Hydraulic 250TT Thruster 8.0 KW 24V System
Commander 400 Series 24V Hydraulic Pump System. System installed as Dual Motor, ten function 24V hydraulic power pack assembly. System installed by Navtec directly
Navtec A320 SYSTEM 50 Hydraulic panel
Dual Racor fuel filtration system allowing independent filter and bypass system
Oil change pump built in as standard for Engine, Genset and Transmission
All wire is tinned, no copper wiring except Selden supplied masthead lights
All thru hull fittings are solid bronze and all bonded
Two 3" copper strips running bow to stern both port and starboard for grounding
1200 AH 24V House Bank for hydraulic systems, winches, anchor windlass and rig controls
All batteries are isolated with a built in reverse isolation switch
Two independent alternators, one 225 amp dedicated to house bank and one 80 amp dedicated to engine start.
All batteries to be Lifeline AGM maintenance free batteries. House bank to be located underneath aft stateroom berth
2" lead lined fire retardant engine room sound insulation
Aqua Signal Navigation Lights; running lights, masthead anchor, tricolor steaming light and foredeck light
ST60 Depth sounder, speed log and wind speed Indicator
S-2A Firebuoy Fuel Vapor Monitor
MS-2/25' Xintex Propane/CNG Sensor
M-4124RC Cole Hersee Dual 24V Fuel/Water Alarm System
#51211Pro 10-3 Flyback 10A 12V PM Battery Charger
#299017 Mastervolt Battery Charger 24V/80A 230V 50/60HZ
#299017 Mastervolt Battery Charger 24V/80A 230V 50/60HZ
Two 24V/12V DC/DC Mastervolt 20A Step Down Chargers
35400-0000 JABSCO Engine Room Blower 4" 12V
87178 Hella Two speed Jet Fan 12V, fourteen total
Aqualoy 22 Shaft WBM 2"X115"
Engine and generator starting batteries to be 4D AGM Lifeline 12 V batteries
Fresh air feed to engine room, (possible Dorade or rear feed with water trap.)
Newmar galvanic isolators to be located in line before main circuit breakers for safety ground line ( in garage)
ALL A/C distribution panel neutral and grounding circuits to be ordered on distribution panel consistent with positive wiring. FIRST position on AC main breaker panel to be blank, 30 A breaker. Terminal blocks to be used for neutral and grounding wiring (NO EURO spring panels)
480 gallons of water in four stainless tanks
600 gallons of fuel in four stainless tanks
Two independent bilges pump systems, one Rule 3500 gph system, one Par 3000 gph system. Total of 6500 gallon/hour with Bilge Bug conductive switches.
Options available to increase and/or change balance of total and type of tankage
All tanks have easy access for inspection with dipsticks, threaded inspection port and larger inspection port for interior inspection and cleaning.
S1950 Seaward 18 gallon hot water heater SS 220V
WSC-60/24V GROCO washdown pump 24V
PAR-MAX 4 Bilge Pump 24v
Two PAR-MAX 3 PUMP 24V water pump
Jabsco H/D Mascerator Pump 24V for galley sink
GW2229B Whale Waste Tank w/ Float
BP3740 Whale Gusher 10 Manual Bilge Pump
302400 Sealand T-Series odorless discharge hose for all heads
10590-0001 Jabsco H/D Mascerator Pumps 24V for waste tanks
Groco Bronze In Line water strainers for engine, refrigeration units and generator
Galley and Heads
Force 10 Four Burner LPG stove
Two 20LB Trident Aluminum LPG tanks
U-Line Ice Maker
Separate standing refrigerator with Frigiboat Refirgeration System and Danfloss Compressor
Front and top loading freezer with Frigiboat Refrigeration and Dual Danfloss Compressors
Wahlee Stone counters in galley. Owner to choose color
Raritan PHII Manual Heads. Option for Raritan Electric heads or Vacuflush heads
GP1309B Whale Foot Pump
Choice of several sink designs. All sinks in Brushed Stainless or FRP.
Add opening port to owners shower, for a total of two, in head and shower.
Hylas Yachts offers its owners a unique opportunity to customize their interiors to a level that very few builders allow. In addition many of these changes cost very little or are no cost, which offers and increases the value of their yacht considerably.
Choice of customized teak or maple interior with options for bamboo sole and other hardwoods
Solid teak soles laid on sealed sub flooring with epoxy urethane coating and 7 layers of varnish
Solid teak doors and trim
Finely finished cabinetry with a choice of solid or louvered finish
Solid teak handrails throughout the interior for easy movement offshore
Abundant overhead hatches and ports for excellent ventilation
Epoxy sealed endgrains and subflooring
All cabin sole pieces are positive locking for offshore passagemaking
All cabinets are finished throughout including complete interiors
All overhead headliner is easily removed for access to hardwareHylas 70 Standard Specifications and Equipment
|
